Optional presentation practice. Choices and model launches do not write LMS grades, completion or certificates.
Distinguish credible fire and explosion mechanisms so controls match the released material and conditions.
A process-fire assessment begins with the substance, its condition and how it could be released. A liquid pool, a dispersed cloud and a pressurised jet present different fuel configurations. The ignition opportunity and the people or equipment exposed also vary.
The training task compares a pool, a pressured spray and a delayed-ignition cloud; a draft plan gives all three one identical response assumption.
A combustible cloud or dust in a connected system can produce consequences beyond its first location. Geometry, confinement and routes of propagation affect the potential event. A source described as small does not by itself establish a small consequence.
A boiling liquid expanding vapour explosion involves sudden failure of a vessel containing liquid above its atmospheric boiling temperature. Rapid flashing and expansion can create severe blast and fragments.
A briefing says a vessel containing a non-flammable pressurised hot liquid cannot create a BLEVE hazard.
Flammability affects additional consequences; it is not the sole physical basis of a BLEVE.
A release can disperse and mix with air before ignition occurs. A flammable cloud may produce a flash fire or, where conditions support significant pressure generation, a vapour-cloud explosion. A release does not automatically become either a fire or an explosion.
Flame, radiation, blast and escalation depend on release, ignition timing and confinement. A pressurised vessel BLEVE is a distinct mechanism, not a label for every atmospheric tank fire.
Hold the oversimplified planning conclusion and use competent scenario review to establish the relevant prevention, mitigation and response.
A jet fire follows ignition of a continuing pressurised release. A pool fire involves burning material collected as a liquid pool. The release mechanism affects direction, spread and escalation. Both can cause severe thermal exposure, but their source-control and protective requirements must fit the actual scenario.
A BLEVE involves sudden vessel failure and rapid expansion of liquid held above its atmospheric boiling point. The physical event can produce pressure effects and fragments. If the released material is flammable, ignition can add a fireball and severe thermal consequences.
Return to the same fictional model case. Select the evidence needed before relying on the control.
Trace each scenario in the risk assessment to appropriate barrier evidence and practised response; ensure the fictional terminal is not falsely described as an LPG pressure-vessel installation.
A temporary reactor bypass ruptured and a vapour-cloud explosion followed. The investigation identified inadequate assessment and verification of the plant modification.
Apply the learning from Flixborough, 1 June 1974 to the current task.
Trace the release, mixture and ignition, and distinguish pressurised-liquid rupture.
Use the full course for detailed teaching, required activities and the separate final assessment. Presentation choices are practice and do not write LMS grades or completion.
The PowerPoint contains the presentation and notes. Enable JavaScript for the online choices and classification activity.